• high pressure duct fan to exhaust air and fumes through long lengths of rigid or flexible ducting
• super silent two speed models
• hole diameter:

MF250s - 4"/10cm or 5"/12cm

• integral spring loaded backdraught shutter
• anti-vibration gasket
• adjustable timer - 3-25 minutes
• dynamic humidistat with night time set back and anti-hunting device
• humidistat model with neon to show fan in manual operation
• backward curved centrifugal impeller to ensure near silence on low speed operation
• filters available
• IPX4 - Splashproof - can safely be installed in Zones I and II

• casings from high quality, impact resistant, white thermo-plastic material with high mechanical strength
• double insulated motors of shaded pole type mounted on self-lubricating, sealed ball bearings for long life
• motor windings protected to Class B
• motors incorporate thermal cut-out
• maximum ambient temperature - 40°C

• EN60335-2-80
• EC Low Voltage Directive 73/23-93/68
• EC Directive EMC89/336
• CE marked

• MF250C - cord or remote
• MF2502C - 2 speed, cord or remote
• MF250T - timer
• MF250H2C - humidistat, 2 speed, cord or remote, neon
• MF250HCT - humidistat, cord, timer neon

• MF250F - filter for above models

2 SPEED MODELS SHOULD BE INSTALLED WITH EITHER A FIXED GRILLE OR COWL

Supply and install a Vectaire MF250H2C high pressure duct fan for toilets, bathrooms and shower-rooms, utility room or kitchen supplied by Vectaire Ltd, Lincoln Road, Cressex Business Park, High Wycombe, HP12 3RH. This fan must have an integral humidistat, two speeds, and be capable of being boosted to its maximum speed by means of a pull-cord. If the humidity has reached a pre-set level, the fan is to start and is to continue to operate at low speed until the humidity has fallen beneath the pre-set level and the timer has completed the over-run period. Pulling the pull-cord override will boost the fan to its maximum speed. Pulling the cord again will make the fan revert to its low speed and to being operated automatically by the humidistat and/or the over-run Timer.The sound level on low speed is to be so low as to be nearly inaudible. This fan is to be suitable for installation either in a ceiling or a wall using 4”/10cm or 5"/12cm ducting. The fan should be complete with an anti-vibration gasket. The fan should be made of shockproof and heat resistant plastic, contain a motor mounted on sealed, self lubricating ball bearings and be protected with a thermal cut-out. Fan to comply with all Regulations requirements for installation into a toilet, bathroom or shower-room.